Crankshaft Position Sensor Chevrolet Equinox 2.4L 2010-2017 Location and Replacement

In this video, I show you only the exact location of the Crankshaft Position Sensor (CKP) on a 2010-2017 Chevrolet Equinox 2.4L.

Pinpointing the precise spot where this sensor is mounted on the engine block will save you time and eliminate the guesswork when planning your DIY replacement.

Common Symptoms of a Bad Crankshaft Position Sensor:

• The engine cranks over normally but refuses to start (a sudden hard no-start condition)
• The engine stalls or dies unexpectedly while driving or idling, especially after reaching operating temperature
• The check engine light comes on (frequently with diagnostic trouble codes like P0335 or P0336)
• Severe engine hesitation, stumbling, or random misfires under acceleration
• Rough idling, erratic tachometer (RPM gauge) behavior, or poor fuel economy

Safety First

Always prioritize safety before starting your repair. Make sure the vehicle is parked on a flat, level surface, the emergency brake is securely engaged, and the engine is completely turned off and cooled down to avoid severe burns. Because you are working near the starter motor and interacting with vital engine electronics, you must disconnect the negative battery terminal before starting to prevent electrical shorts or component damage. Protect your eyes and hands by wearing safety glasses and durable work gloves, and always maintain your full focus throughout the task.

Need Help? Ask an Expert

I am an experienced mechanic, and I am here to help you guide your vehicle projects to a successful finish. If you get stuck trying to release the plastic locking tab on the electrical connector, have trouble removing a stuck sensor from the block, or are dealing with a tricky breakdown, leave a message in the comments below. Let me know what you are running into, and I will help you solve your car’s problem!